Grain Growth Dominance on Complex Permittivity of MgTiO3

Authors

  • D. N. F. Abdul Halim University Putra Malaysia
  • M. S Abdullah
  • J. Hassan
  • M. Hashim
  • R. S. Aziz
  • R. Husin

DOI:

https://doi.org/10.24203/ajas.v7i2.5770

Keywords:

Magnesium Titanate, Dielectric Response, Mechanical Alloying, Ceramic

Abstract

Uncovering the relationship between microstructural and dielectric properties is beneficial for designing new dielectric materials for technological purpose. Thus, this work attempts to understand the evolving relationship between complex permittivity and microstructural in magnesium titanate (MgTiO3) at 40 Hz to 1 MHz. Magnesium oxide and titanium dioxide were mechanically crushed using a high energy ball mill for 12 hours via the mechanical alloying method. Pellets were formed followed by a sintering process from 500 oC up to 1400 oC. The phase formations of the sintered samples showed a development in their crystalline structure and their phase was confirmed by X-ray diffraction patterns, yielding a completed phase of MgTiO3 formed at 800 oC. Observation by scanning electron microscopy revealed an improvement in grain growth as the sintering temperatures are elevated. The density proportionally increased with the sintering temperature. From the complex permittivity studies, the dielectric constant, ԑr’ showed a decreasing trend with increasing frequency and attained constant limitation value of ԑr’ at higher frequency at room temperature. Below 104 Hz, the relaxation belonged to the interfacial polarization while beyond 104 Hz, it is dominant by dipolar polarization. The frequency dependence of loss tangent, tan δ decreased with value almost zero at higher frequency for all sintering temperatures. A significant increasing trend was observed which correlated the polarization-crystallinity behaviors at 1 MHz from 500 oC up to 1400 oC. The improvement in microstructure properties with respect to the sintering temperature was observed which give rise to the dielectric permittivity at infinite frequency, ε∞’. It revealed the dependency of dipolar polarization on the grain sizes and the crystallinity of the sample.

Author Biography

D. N. F. Abdul Halim, University Putra Malaysia

I am currently a Phd student in University Putra Malaysia.

References

B.W. Ricketts, G. Triani, A.D. Hilton, “Dielectric energy storage densities in Ba1-xSrxTi1-yZryO3 ceramicsâ€, J Mater Sci – Mater Electron, 11, 513-517, 2000.

A. Belous, O. Ovchar, D. Durylin, M. Valant, M. Macek-Krzmanc, D. Suvorov, “Microwave composite dielectric based on magnesium titanatesâ€, J. of the Eur. Ceram. Society, 27, 2963-2966, 2007.

S. Filipovic, N. Obradovic, V.B. Pavlovic, S. Markovic, M. Mitric, M.M. Ristic, “Influence of mechanical activation on microstructure and crystal structure of sintered MgO-TiO2 systemâ€, Sci. of Sintering, 42, 143-151, 2010.

C.L. Pan, C.H. Shen, P.C. Chen, T.C. Tan, “Characterization and dielectric behavior of a new dielectric ceramics MgTiO3–Ca0.8Sr0.2TiO3 at microwave frequenciesâ€, J. of Alloys and Compound, 503, 365-369, 2010.

G. Pfaff, “Peroxide route for synthesis of magnesium titanate powders of various compositionâ€, Ceramic International, 20, 111-116, 1994.

N. Obrodovic, S. Filipovic, V.B. Pavlovic, A.Maricic, N. Mitrovic, M.M. Ristic, “Sintering of mechanically activated magnesium-titanate and barium-zinc-titanate ceramicsâ€, Sci. of Sintering, 43, 145-151, 2011.

C.L. Huang, C.M. Tsai, A.Yang, A.Hsu, “Compact 5.8-GHz bandpass filter using stepped-impedance dielectric resonators for ISM band wireless communicationâ€, Microwave Opt. Lett., 44, 421, 2005.

J. Bernard, D. Houviet, J.E. Fallah, J.M. Haussonne, “MgTiO3 for Cu base meral multilayer ceramic capasitorsâ€, Jour. of the Eur. Ceram. Soc., Vol 4, 1877-1881, 2004.

K. Sreedhar, N.R. Pavaskar, “Synthesis of MgTiO3 and Mg4Nb2O9 using stoichiometrically excess MgOâ€, Mater. Lett., 53, 452–455, 2003.

N. StubiÄar, A. Tonejc, M. Stubicar, “Microstructural evolution of some MgO-TiO2 and MgO-Al2O3 powder mixtures during high-energy ball milling and post-annealing studied by X-ray diffractionâ€, J. of Alloys Comp., 370, 296–301, 2004.

I.R. Abothu, A.V.P. Rao, S. Komarneni, “Nanocomposite and monophasic synthesis routes to magnesium titanateâ€, Mater. Lett., 38, 186–189, 1999.

V.M. Ferreira, J.L. Baptista, “Preparation and microwave dielectric properties of pure and doped magnesium titanate ceramicsâ€, Mater. Res. Bull., 29, 1017-1023, 1994.

Y. Miao, Q. Zhang, H. Yang, H. Wang, “Low-temperature synthesis of nano-crystalline magnesium titanate materials by the sol gel methodâ€, Mater. Sci. and Eng. B, 128, 103-106, 2006.

W.W. Cho, K.I. Kakimoto, H. Ohsato, “Microwave dielectric properties and low-temperature sintering of MgTiO3–SrTiO3 ceramics with B2O3 or CuOâ€, Mater. Sci. Eng. B, 121, 48–53, 2005.

J. Liao, M. Senna, “Crystallization of titania and magnesium titanate from mechanically activated Mg(OH)2 and TiO2 gel mixtureâ€, Mater. Res. Bull., 30, 385–392, 1995.

B.D. Lee, H.R. Lee, K.H. Yoon, Y.S Cho, “Microwave dielectric properties of magnesium calcium titanate thin filmsâ€, Ceramic Inter., 31, 143–146, 2005.

D. Li, L. Wang, D. Xue, “Stearic acid gel derived MgTiO3 nanoparticles: A low temperature intermediate phase of Mg2TiO4â€, Jour. of Alloys and Comp., 492, 564-569, 2010.

C.C., Koch, O.B., Cavin, C.G. McCamey, J.O. Scarborough, “Preparation of amorphous Ni60Nb40 by mechanical alloyingâ€, Appl. Phys. Lett., 43, 1017, 1983.

C. Suryanarayana, Mechanical Alloying and Milling, New York: Marcel Dekker, 2004.

M.A. Sanoj, C.P. Reshmi, K.P. Sreena, M.R. Varma, “Sinterability and microwave dielectric properties of nano structured 0.95MgTiO3-0.05CaTiO3 synthesised by top down and bottom up approachesâ€, J. of Alloys and Comp., 509, 3089-3095, 2011.

V. Petrovic, “Sintering kinetics of MgO-TiO2 systemsâ€, Sci. of sintering ceramics, 38, 287-292, 2006.

J. Widegren, L. Bergstrom, “Electrostatic stabilization of ultrafine titania in ethanolâ€, J. Am Ceram. Soc., 85, 523-528, 2002.

S. Joong, L. Kang, Sintering Densification, Grain Growth and Microstructure,

Elsevier/Butterworth-Heinemann, London, 2005.

I. Ismail, M. Hashim, “Sintering temperature dependence of evolving morphologies and magnetic properties of Ni0.5Zn0.5Fe2O4 synthesized via mechanical alloyingâ€, J. Supercond Nov. Magnetic, 25, 1551-1561, 2012.

R. L. Coble, “Sintering crystalline solids. II. Experimental test of diffusion models in powder compactâ€, Jour. Applied Phy., 32, 793-799, 1961.

A.A. Saif, P. Poopalan, “Correlation between the chemical composition and the conduction mechanism barium strontium titanate thin filmsâ€, J. of Alloys and Comp., 509, 7210-7215, 2011.

M. Chanda, Science of engineering materials, Vol. 3, the Macmillan Company of India Ltd. 1980.

C. Mao, S. Yan, S. Cao, C. Yao, F. Cao, G. Wang, X. Dong, X. Hu, C. Yang, “Effect of grain size on phase transition, dielectric and pyroelectric properties of BST ceramicsâ€, J. Of Eur. Ceramic Soc., 34,) 2933-2939, 2014.

R.V. Mangalaraja, P. Manohar, F.D. Gnanam, M.Awano, “Electrical and magnetic properties of Ni0.8Zn0.2Fe2O4/silica composite prepared by sol-gel methodâ€, J. Mater. Sci., 39, 2037, 2004.

Downloads

Published

2019-04-20

How to Cite

Abdul Halim, D. N. F., Abdullah, M. S., Hassan, J., Hashim, M., Aziz, R. S., & Husin, R. (2019). Grain Growth Dominance on Complex Permittivity of MgTiO3. Asian Journal of Applied Sciences, 7(2). https://doi.org/10.24203/ajas.v7i2.5770

Issue

Section

Articles